Industrial Wireless / Wireless Radio I/O Extender
Wireless Radio I/O Extender
DD1000/SRM/2.4 or DDAA1000/SRM/2.4
Features :
* Easy to implement
* Field configurable
* Automatic restart
* No special software required
* Point-to-point or point-to-multipoint data acquisition and control
* Inexpensive to install—no wires to route or ditches to dig
The Data-Linc Group DD1000/SRM and DDAA1000/SRM wireless multiplexers offer applications the ability to transmit 4-20mA and/or discrete signals without the cost or inconvenience of adding wires or additional devices.
The DDAA1000/SRM combines an analog/discrete signal digitizer with Data-Linc Group’s SRM industrial grade license-free wireless modems. The result is a simple to implement solution for I/O signal transmission.
Each DDAA multiplexer has eight discrete inputs and eight outputs, as well as eight analog (4-20mA) inputs and outputs.
The DD1000/SRM is as described above but offers only the discrete function.
The radio section of the multiplexers incorporate the license free 2.4 GHz-2.4835 spread spectrum ISM (industrial/scientific/medical) band technology used by the Data-Linc Group SRM Family of radio modems. (Also available for the 900 MHz band.) These units are capable of wireless transmission up to 15 miles (24 km) with line-of-sight and an omni directional antenna.
In the event of a communications link failure, discrete outputs will default to open, while analog outputs will default to 4 mA.
Applications
* Mining
* Water/Wastewater- monitor tank levels via
4-20 mA analog signals and control pump
contact closure via discrete signals
* Most types of discrete 4-20 mA applications
DD1000/SRM/2.4 and DDAA1000/SRM/2.4 Specifications
System Configurations
Point-to-point, point-to-multipoint; 1 Master multi-dropped with up to 8 addressable single channel Remotes
Channel Functions
Analog. 4-20mA standard, 24VDC max. Internal 8 Bit
A/D yields 2% accuracy of 4-20 signals
Discrete Input. Dry contact closure-switch closure detection
Discrete Output. Open collector— sync to ground 100mA per
channel 12-24VDC
Operating Environment
Standard. 32° to 140° F (0° to 60° C)
Humidity. 0 95% non-condensing humidity
Connections
RF Antenna: Standard thread SMA female.
Supplied bench test 0dB whip antenna.
Optional external omni directional or yagi antennas available.
Analog. (4-20mA input and output):
9 Position pluggable terminal blocks
Pluggable terminal blocks standard wire size 12-26 AWG
Digital. (Contact closure input and output):
9 position pluggable terminal blocks
Pluggable terminal blocks standard wire size 12-26 AWG
Power. Barrel jack (2.0 mm center, 6.5 mm barrel)
120 to 12 VDC barrel jack transformer included
Configuration. 6 pin mini-din. RS232 port used for reconfiguration of RF and
processor channel parameters.
Supplied programming cable and Software CD with each Master unit.
Indicators
Power.
CD (Carrier Detect)
Tx (Transmit Data)
Rx (Receive Data)
Status (Error Status, Master unit only)
Voltage and Current
Voltage: 12VDC nominal, Min 10.5, Max 18VDC
Current: 160mA idle, 660mA Peak on Transmit
Enclosure
Standard. 18-gauge steel with mounting flanges
Weight. 4 lb (1.82 kg) See diagram below.
2.4 GHz Versions of DD1000/SRM and DDAA1000/SRM
DD1000/SRM/M/2.4GHz (Master unit)
Discrete signal multiplexer with integral radio modem:
2.4-2.4835 GHz license free radio modem with 8 discrete Inputs and Outputs.
DD1000/SRM/R/2.4GHz (Remote unit)
Discrete signal multiplexer with integral radio modem:
2.4-2.4835 GHz license free radio modem with 8 discrete Inputs and Outputs.
DDAA1000/SRM/M/2.4GHz (Master unit)
Discrete and Analog signal multiplexer with integral radio modem:
2.4-2.4835 GHz license free radio modem with 8 discrete Inputs and Outputs as well as 8 analog Inputs and Outputs.
DDAA1000/SRM/R/2.4GHz (Remote unit)
Discrete and Analog signal multiplexer with integral radio modem:
2.4-2.4835 GHz license free radio modem with 8 Discrete Inputs and Outputs as well as 8 analog Inputs and Outputs.