For Modbus protocol conversions, it is necessary to define a Master and Slave device, but unlike other Modbus Gateways, NPort 6110 allows users to configure Master/Slave for both the Ethernet and serial sides. Extra address mapping and exception parameters are supplied to ensure that most situations can be handled.

NPort 6110 is powerful yet very easy to use. An intuitive Windows utility automatically searches for all available NPort 6110 units on the LAN. Traffic monitoring within the utility helps you troubleshoot any Modbus communication problem, such as connection status check, or address translation error check.

Let traditional Modbus serial devices talk over the Internet
Many traditional serial Modbus devices can talk over RS-485, but the RS-485 network limits the maximum number of Modbus devices to 32, within 1.2 km. By using Modbus Gateway, you can link all Serial Modbus devices over an Ethernet network. Up to 8 Modbus Gateways can be installed in the same control network, extending the coverage of a single Modbus network as far as a TCP/IP network can reach.

Connect all Modbus devices over the Ethernet network
Most host computers and newly developed PLCs support the Ethernet interface and run Modbus/TCP. NPort 6110 Modbus Gateway is needed to link discrete Serial Modbus Devices for data collection and control. Each NPort 6110 supports Modbus/TCP over Ethernet, which allows up to 7 connections. The software configurable serial interface supports either RS-232 or RS-422/485. In RS-232/422 modes, NPort 6110 can connect to 1 serial device. One NPort 6110 supports up to 31 serial devices under RS-485 mode, which is the most popular application for the factory floor.

Link the Serial Master device with Ethernet Slave devices
Many HMI (Human Machine Interface) systems use a serial interface and are required to access a discrete DCS. These days however, more and more DCSs support Ethernet and run under Modbus/TCP slave mode. In this case, NPort 6110 Modbus Gateway is the ideal solution to link the HMI to distributed DCSs over an Ethernet network. Up to 4 Modbus/TCP slave devices are supported for each NPort 6110.

Configure Modbus Gateway Anywhere on the LAN
Once NPort 6110 is connected to the Ethernet, any Windows host computer running Modbus Gateway Configurator can automatically search for all installed Modbus Gateways, and then proceed with configuration. DHCP (Automatic IP settings) and Manual IP settings are both supported. Such user-friendly features make NPort 6110 one of the most easy-to-use Modbus Gateways in the world.

Online Traffic Monitoring and Error Log Display
Modbus communication troubleshooting is both fast and easy. NPort 6110's utility lets you monitor the online configuration and connection status from anywhere on the network without interfering with operation. Meanwhile, the system log can be stored as an installation or service record.

In addition to working with most Modbus devices, NPort 6110 provides both basic and advanced communication parameters. For example, in addition to general configurations, Remote Modbus/TCP device ID, Initial Delay Time Adjustment, and Character/Message Timeouts are adjustable right in the Windows utility. Unlike text-based configuration from other vendors, NPort 6110's comprehensive utility eases installation and saves training cost for engineers.

• Modbus serial and Ethernet device integration
• Supports Modbus/TCP Master device to Modbus/ASCII/RTU slave devices (up to 31)
• Supports Modbus/ASCII/RTU master device to Modbus/TCP slave devices (up to 4)
• Easy-to-use Windows utility for configuration over Ethernet
• 10/100M fast Ethernet with automatic IP setting (DHCP)
• One software selectable RS-232/485/422 interface
• High speed serial up to 230.4 Kbps